Keeping Your Battery Clean To Remain Safe



Have you ever attempted to jump start your car battery and was shocked that it was covered in gunk? That gunk that spreads over the battery is actually corrosion formed by acid condensation. It can be cleaned using a simple chemical solution, since it has been formed by an acid. A familiar household product, specifically baking soda, can easily clean battery acid very easily. You need to be mindful when doing it but there are just a couple instructions on how to clean your battery.

The very first thing you'll want to do is to get the necessary supplies, which you may already have at home. Protection glasses can be nice to have for shielding your eyes, a box of baking soda is a necessary ingredient, adjustable pliers and screwdriver, with insulated handles, and a stiff-bristled brush to begin with. Additionally, you will need open-end and box wrenches, some sort of scraper either metal or plastic, cleaning brushes for the battery terminal along with a turkey baster or small funnel. A few sponges or perhaps clean cloths, a spray bottle with all-purpose household cleaner, some rubber gloves and a large bucket of clean water. This may seem like a lot of things for cleaning a battery, but we did say doing it safely.

You'll have to have the safety glasses and rubber gloves to protect yourself from the sulfuric acid that's contained in the corrosive deposits. You should also make sure that the deposits avoid getting on the car since it will damage the paint. Based on the measure of dirt and corrosion on the battery, the cleaning can vary, and some of the steps might not be necessary. If you'd like the battery to get very clean, you will need to remove the battery from the vehicle. The first task is to use the scraper to clear out as much dirt as possible and use the bristle brush to get at more.

Next step will be to mix one tablespoon of baking soda with a pint of water and apply the solution to the battery and the cable connection using the funnel or turkey baster. Work the mixture of baking soda directly into the heavily corroded spots with the brush, and disconnect the battery cables from the terminals for easier cleaning. Make use of the pliers or assorted wrenches to loosen the hookup before pulling them off, starting with the negative first, and then the positive. Brush off much of the corrosion from the terminals and all of the parts, and then flush each Extra resources one with the baking soda solution.

You can use the bottle of spray cleaner and sponge to remove any excess dirt and grease. Dry everything off using a clean cloth and then reassemble everything the way you took it apart, reconnecting the positive first. Lastly, be certain that everything is attached and now you have a clean and safe battery.

Leave a Reply

Your email address will not be published. Required fields are marked *